Dealer program now accepting applications — apply online in minutes. Learn more

Installation

Installing an Overhead Track: A Step-by-Step Guide

The order of work for hanging overhead door track with a Thunder Mounts TMGT set, and the checks that keep it square.

Hanging overhead track is a two-person job with a fixed order of work. Change the order and you end up holding a track in the air while you look for a bolt. This is the sequence, and the checks that matter at each stage.

It assumes a TMGT track mount set — one set per overhead door, with hardware, chrome ring and online instructions included — and a ceiling you have already confirmed is structure, not drywall.

1. Set out the two mounting points

Measure the span from the ceiling to each track mounting point, then mark both. Take the measurement at both ends: the ceiling is rarely parallel to the floor, and a set hung from two different spans will lean.

2. Fix the mounts to the ceiling first

Mounts go up before the track does. Fix into joists or truss chords, using fixings appropriate to the structure. Check the two mounts are level with each other across the door before tightening anything down — this is the single check that decides whether the finished job looks square.

3. Assemble to the measured span

Assemble each mount to its own measurement, up to the maximum of the length you bought. Do not assume both sides are the same.

4. Hang the track

With two people, lift the track into place and bolt it to the mounts, leaving the bolts snug but not final. The track should hang under its own weight without being held.

5. Check, then tighten

  • Level across the door, at both ends.
  • Square to the opening — the track should run true to the door's travel, not to the wall.
  • Both sides at the same height where the design calls for it.
  • Every fixing tight, and no bolt left finger-tight.

6. Fit the closing trim

The chrome ring is the finishing piece; fit it once everything above is final, not before.

7. Run the door

Operate the door slowly by hand before you power anything. It should travel without binding, and the track should not flex visibly as the door moves. If it does, stop and find out why — the mount is holding a moving load, and a flexing track is telling you something.

What this guide is not

It is not a substitute for the instructions that ship with the mount or for the door manufacturer's installation requirements. Those are the authority; this is the order of work.

All articles Shop Products