Dealer program now accepting applications — apply online in minutes. Learn more

Installation

Preparing Your Garage for an Opener Mount Installation

A simple checklist of measurements, tools and ceiling considerations to sort out before you start.

Most of the time lost on an opener mount installation is lost before the first bolt goes in: a measurement taken from the wrong side of the ceiling joist, a ladder that will not reach, a garage that has been used as a workshop for a decade. Twenty minutes of preparation saves an hour on the ladder.

Before you buy: measure the span

Thunder Mounts come in four maximum lengths — 12, 19, 24 and 29 inches. What decides which one you need is the distance from the ceiling structure to the point the mount attaches: the opener motor flange for TMS, TMX, TML and TMMRT, or the overhead door track for a TMGT set.

  1. Measure from the underside of the ceiling to the top of the opener flange (or the track mounting point).
  2. Round up to the next length rather than down. A mount at its maximum extension is doing what it was designed to do; one that has to be forced is not.
  3. Check that the ceiling above the measured point is structure — a joist, a truss chord, or a solid fix into one. Drywall alone is not a fixing point for anything that carries load.
  4. Take the measurement at both ends of the track if you are fitting a set. They are frequently not the same.

What to have on site

  • A step ladder tall enough that you are not working at full reach, and a second person for a track set.
  • A tape measure, a pencil and a level. The level is the one people skip; it is the reason some installs look right in the middle and wrong at the ends.
  • A drill and bits suited to the fixing you are using, plus the fixings themselves — the mount ships with its own hardware, but the ceiling fixing is specific to the structure.
  • Gloves and eye protection. Galvanised steel and drilled holes produce sharp edges and metal filings.
  • The installation instructions for your series, online or printed.

Clear the floor

It sounds trivial. It is the difference between a job where the ladder sits flat and one where it wobbles on a stack of boxes. Move the car, and give yourself a metre either side of the door track.

Check the opener

Mounts are not sold with openers attached, and compatibility with a specific opener model should be confirmed with Thunder Mounts before ordering. Have the make and model to hand; for Marantec-style openers the TMMRT series is the mount designed for that flange pattern.

Two people, one of whom has done it before

The manufacturer's instructions are written to be followed. If this is your first installation, reading them once on the ground before climbing the ladder is worth more than any tip on this page.

All articles Shop Products